Rubber sleeve power cable repair method:

First, equipment: with automatic temperature control, timing and multi-size tubular cavity of the small pressure equipment.

Second, the compound: the wire with the wire consistent, and the amount of glue is higher than the material being added, slightly stronger curing system.

Third, the operating method:

1.according to the curing system of rubber set temperature and time

2.with rubber ink thinner Sassafras washing repair, especially the combination should be fully treated.

3.according to the size of the gap to cut the amount of repair rubber compound, pay attention to not more or less,

4.will cut the rubber stuffed in the gap, pay attention to the rubber material should not be higher than the circumferential surface.

5.with high temperature PP with a good package. And placed in a slightly smaller than the diameter of the tubular cavity, locking the upper and lower mold, so that the position has a certain pressure. Note that the cavity diameter is slightly smaller than the diameter of 0.1 ~ 0.2mm.

6.to be vulcanized time, remove the product, if a small amount of rubber spill, with a sharp blade repair, and can be used to thinner Sassafras.

Fourth, the verification method:

Will be the amount of air into the wire and put in the water, see whether the phenomenon of leakage can be judged good or bad.

The above is a brief description of how to repair the power cable, learn more about the power cable content, please pay attention to kingsignal official website.